While squeezing the body halves together, begin tightening the middle bolt that the trigger pivots around. Carefully pick up the right half of the body and line up the spring into the recess, then bring together and 'snap' into place over the locators. Install the locators, then drop the gun bolt, magazine release, and spring in place. Drop your trigger in, and secure the o ring between the post on the trigger and the forward most M3 bolt. Screw your three M3x12 bolts into the left half of the body, flush with the flat face. (Optional) 3 x M3 nuts if you choose to print the Hex version Rubber o-ring, orthodontic rubber band, etc. Ballpoint pen spring cut in half for the magazine release Printed locators for alignment during assembly Feel free to modify as needed for the time being but please refrain from distributing said modifications. I cleaned up the original game meshes and scaled it to match the Ruger Mark IV which it is based on.Ģ50x250 build plate currently required to print the body halves as one piece. 22LR pistol from the game Fallout: New Vegas. This is my 'functioning' interpretation of the silenced.
